the difference between solid and ribbed slab

Cost Comparison Between Different Types of Reinforcing Concrete ...

ribbed slab was the least expensive with a value 490,887.00 SDG followed by a two ..... beams slabs may be solid of uniform thickness or ribbed with ribs running in ... the main objective of this comparison is to design slabs which are lighter.

Advantages of Rib (Clay pot) slab over solid (concrete) Slab - LinkedIn

13 Jan 2017 ... Hollow blocks are used to fill portions of the slab thickness; this results in deeper arm for the reinforcement while saving the amount of concrete and hence the own weight of the slab. the reinforcement is located between the ...

What is a flat slab? What is the difference between a flat slab ...

Hi, Flat slabs are used very commonly in commercial buildings. A flat slab is a typical type of construction in which a reinforced slab is built monolithically with the supporting coumns and is reinforced in 2 or more columns , without any provisi...

What is the difference between a flat slab and a ribbed slab? - Quora

7 Sep 2017 ... Two way slabs directly supported on columns are called flat plates. the main limitation of flat slab is the problem posed by resisting two-way shear (Punching shear) around the columns. Hence, for heavy loads or long spans, ...

Cost Comparison Between Frames with Solid Slab and Ribbed Slab ...

Cost Comparison between Frames with solid slab and ribbed slab using HCB under Seismic Loading Deressa Ajema1, Ameyu Abeyo2 1,2 Assistant Lecturer, Dept. of Civil Engineering, Bule Hora University, Bule Hora, Ethiopia

What is the difference between a deck slab and a solid slab? - Quora

the term Deck slab is mainly related to Bridge Engineering, where the slab acts as a deck or carraigeway for the vehicles to commute. Deck slab can be a both, solid and hollow. In case of a viaduct or flyover built with precast box girders with ...

Ribbed or Waffle Slab System - Advantages & Disadvantages ...

A 120-mm-thick slab with a minimum rib thickness of 125 mm for continuous ribs is required to achieve a 2-hour fire rating. A rib thickness ... A solid drop panel is required at the columns and loadbearing walls for shear and moment resistance.

a comparitive study of solid slab with ribbed slab in bale ... - IJMTER

A 120-mm-thick slab with a minimum rib thickness of 125 mm for continuous ribs is required to achieve a 2- hour fire ... related to the comparison of ribbed slab and solid slab interims of cost quality and time. the comparative study has been ...

(PDF) Comparison between Ribbed Slab Structure using ...

Comparison between ribbed slab Structure using Lightweight Foam Concrete and solid slab Structure using Normal ... the result of this study shows that one-way ribbed slab with beam used in residential building is more preferable from the ...

Ribbed and waffle slabs - The Concrete Centre

Waffle slabs tend to be deeper than the equivalent ribbed slab. Waffle slabs have a thin topping slab and narrow ribs spanning in both directions between column heads or band beams. the column heads or band beams are the same depth ...

What is the basic difference between a slab and beam? - Quora

difference in structural role: slabs usually carry a uniformly distributed load and form the floor or roof of the building, and are designed to transfer the load to columns (basically the edges on which the slab rests), while beams are designed to...

(PDF) Assessment of Cost Variation in Solid and Hollow Floor ...

12 Jul 2017 ... therefore there is difference in the cost of construction between the solid and hollow slabs but the difference is not appreciable. the study's major recommendation is that, adequate and careful analysis must be done in the ...

Comparison between Ribbed Slab Structure using Lightweight ...

Comparison between ribbed slab Structure using Lightweight Foam Concrete and solid slab Structure using Normal Concrete.

Hollow block and ribbed slabs - SlideShare

2 Jul 2013 ... 10 Comparison between different codes Limitations of Hollow block slabs : Limitations of ribbed slabs: ... mm 100 × 250 mm Cross ribs No cross ribs No cross ribs One cross rib No cross ribs solid part Short dir. long dir.

Cost Comparison between Frames with Solid Slab and Ribbed Slab ...

Download Citation | the aim of this study focus on problems associated with careful evaluation, Comparison of Overall Behavior (Shear, Bending, Storey Deflections) and comparison of Frame with solid slab and ribbed slab considering ...

Cost Comparison between Frames with Solid Slab and Ribbed ... - Irjet

Cost Comparison between Frames with solid slab and ribbed slab using HCB under Seismic Loading. Deressa Ajema1, Ameyu Abeyo2. 1,2 Assistant Lecturer, Dept. of Civil Engineering, Bule Hora University, Bule Hora, Ethiopia.

Engineering: What are the basic differences between one-way and ...

For the transverse direction, a minimum amount of shrinkage reinforcement is provided. One-way slab action is assumed in a ribbed floor (slab with joist beams) made of precast double tee sections, in ribbed floor with integral beams, and also ...

What is the function of rib slab? - Quora

A ribbed slab or double T slab, because it looks like TT in the construction from below,this shape helps to carry more weight and it is very useful in a heavy loaded areas like car park and below floors, basically it reduces dead weight and ...

Comparison between Ribbed Slab Structure using Lightweight ...

Comparison between ribbed slab Structure using. Lightweight Foam Concrete and solid slab Structure using Normal Concrete. Rana Shabbar. C. , Norizal Noordin, Eethar T. Dawood and Mohd Zailan Sulieman. Building Technology ...

Estimating the Economic Quantities of Different Concrete Slab Types ...

Some of the most widely accepted values are (60-80 kg/m<sup>3</sup>) for solid slab and (120-140 kg/m<sup>3</sup>) of flat slabs. This paper aims to evaluate the ... Rib ties are ranged between 6-300 to 8-200, average weight/m<sup>2</sup> is 0.040 L2. Top slab mesh is&nbsp;...